Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1885
Views
0
Helpful
1
Replies

MGCP Gateway config - FXS ports

blackswans
Level 1
Level 1

‎01-26-2009 06:05 AM - edited ‎03-15-2019 03:46 PM

Hi,

I have configured my cisco 2811 as an mgcp gateway. It has 4 fxs ports on it, I also configured them. It will connect to another non-ip telephony-system from these fxs ports. When our users will call 1111 they have to reach the other system. But is it ok to give these fxs with the same dn or shouldnt I give any dn to these ports ? How to forward if one fxs is busy to the second fxs?

Also can I ask what Unattended Port port means ? And attendant dn?

thanks

Labels:
0 Helpful
1 Reply 1

ivillegas
Level 6
Level 6

‎01-30-2009 08:52 AM

Unattended Port is used for out of dialog REFER processing.

Configuring an attendant DN is to indicate where incoming calls need to be forwarded since the VIC-FXO card is not a direct inward dial (DID) card.

Configure MGCP Gateway and FXO/FXS Ports on a Cisco CallManager Server:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008017825e.shtml

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents