Solved: FAX on UC520 - Cisco Community

490

Views

0

Helpful

2

Replies

I have a UC520 system with a PRI. How do I get a fax machine connected and configured to support inbound and outbound faxes?

The PRI has 100 DIDs and '99' is going to be used for the fax. The fax is plugged into FXS port '0'.

1 KB

1 Accepted Solution

Accepted Solutions

voice service voip

modem passthrough nse codec g711u

dial-peer voice 1 pots

port 0

destination-pattern 99

That's about it. You will need to adjust your 'port' command to which 'voice-port' it corresponds to, like 1/0, 0/0/0, etc.

Make sure 'show controllers t1' doesn't have any slips/errored seconds.

hth,

nick

View solution in original post

2 Replies 2

voice service voip

modem passthrough nse codec g711u

dial-peer voice 1 pots

port 0

destination-pattern 99

That's about it. You will need to adjust your 'port' command to which 'voice-port' it corresponds to, like 1/0, 0/0/0, etc.

Make sure 'show controllers t1' doesn't have any slips/errored seconds.

hth,

nick

That helps quite a lot.

Thanks,

Jeff

Learn, share, save

Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.

New here? Get started with these tips. How to use Community New member guide

Log in to Community