Hello everyone! We have a Cisco 2125 Wireless LAN Controller with Cisco 1130AG Access Points.
Is there a way to configure the WLC 2125 to allow only a certain number of connected/associated wireless users
per access point?
If so, how would I make that change?
By default the WLC is set for 12 clients, before it throws an error about load violation. The way this works, is when the 13th and beyond client attempt to associate, we send them a message type 17, to try and convince the client to go to another AP that is less busy. On the 4th attempt, the client is allowed on the network.
At this time, we do not have a way to hard set the limit of clients on a per AP basis, as the association and roaming logic is on the client and not the AP.