01-26-2009 11:44 AM - edited 07-03-2021 05:03 PM
Hi,
We recently purchased a few more 1131 APs for a remote office. For some reason, only one came as LWAPP AP, and the rests are all Autonomous APs.
I have successfully upgraded one Auto AP into LWAPP, it is under control of that office's WLC.
The image I downloaded is the latest one : c1130-rcvk9w8-tar.124-10b.JA3.tar, I am not too sure if I should have used c1130-rcvk9w8-tar.123-11JX1.tar
However i noticed that the product ID still shows up as AIR-AP1131AG-E-K9 instead of AIR-LAP1131AG-E-K9 like the one came with LWAPP. How to fix this, is this matters. Any help will be highly appreciated.
01-26-2009 12:21 PM
The image you used is fine for the conversion. The AP will use the code it gets from the controller anyway, so you don't need to worry there.
And sorry, but the product ID never changes. The AP was an AP when it was produced, and it will forever remain an AP. It cannot become an LAP, at least as far as the product ID is concerned.
01-26-2009 01:13 PM
Thanks Jeff for your quick reponse.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide