Disassociate APs from controller

Unanswered Question
Jan 26th, 2009


we have two controllers with 32 APs. Today all the APs associated to 1st controller got de-associated.Eventhough it did not associated to 2nd controller.

Can someone advise me why this has happend and what are the required configurations needed to work active/standby or share the AP association between two controllers.

thanks in advance !

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Leo Laohoo Mon, 01/26/2009 - 15:35

What is the Firmware of the two WLC?

If v3.x/4.x/5.x (before 5.2), try the following commands from the WLC:

config ap primary-base

config ap secondary-base

This forces the AP to "point" to the primary/secondary WLC immediately after bootup.

If your Firmware is 5.2, then use the command:

config advanced backup-controller primary

config advanced backup-controller secondary

Does this help?


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode