Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
638
Views
0
Helpful
1
Replies

Monitoring 3825 with MIB

ogadri
Level 1
Level 1

‎01-27-2009 12:35 AM

I have to monitor a Cisco 3825 I'm using in order to interface PRI PBXs; 3825 is SIP controlled.

SW version: Cisco IOS Software, 3800 Software (C3825-IPVOICE_IVS-M), Version 12.4(21), RELEASE SOFTWARE (fc1)

I would like to know which are the MIBs i have to consider in order to get information and then monitor voice calls both per each E1 and the total amount (number of calls, rejected calls, total amount for erlang, lost calls, DSO busy/idle...) and also monitor the IP interface (uplink to IP network) from bandwidht point of view, pps,..

Thanks in advance

Simone

Labels:
0 Helpful
1 Reply 1

drolemc
Level 6
Level 6

‎02-02-2009 04:08 PM

Below show the MIB objects that correspond to the output of these VoIP verification commands:

show voice port summary (for NM-2V card only)

show voice call summary

show dial-peer voice summary

show call active voice brief (for Cisco 3600 platform only)

show voice dsp (for NM-HDV card only)

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents