communication with citrix

lomuwagun · ‎01-27-2009

i needed to allow users to be able to connect to a remote citrix server. After allowing all the ports on my firewall, the port status is still showing blocked. below is an extract of my config

access-list outside_access_in extended permit tcp any eq citrix-ica any

access-list outside_access_in extended permit udp any eq 1604 any

access-list outside_access_in extended permit tcp any eq 2598 any

how can i get this thing to work.

Jithesh K Joy · ‎01-27-2009

Hi

The above access-list will not allow you to initiate a citrix connection. please try the following.

access-list outside_access_in extended permit tcp any any eq citrix-ica

access-list outside_access_in extended permit udp any any eq 1604

access-list outside_access_in extended permit tcp any any eq 2598

lomuwagun · ‎01-27-2009

thks. Just tried your solution but its not going trough. if i use port scan, i still receive the message that the port is closed.

hunnetvl01 · ‎01-27-2009

Your ACL is inbound on the inside interface, right?

Vlad

hunnetvl01 · ‎01-27-2009

Something else:

How do you use the port scan>

Did you check that there is no windows firewall enbled on the PCs?

Jithesh K Joy · ‎01-27-2009

Hi,

Could you please refer the below link & open corresponding ports depending on your environment. As Hunnet said in the prevoius conv, can u confirm that the you are doing the port scan from right direction?

http://www.dabcc.com/article.aspx?id=1755

regards

Jithesh