Card type command not accepting

Unanswered Question
Jan 27th, 2009

We are unable to run the Card Type command on Cisco 2811 Router the IOS Image deployed is c2800nm-adventerprisek9-mz.124-22.T.bin

Kindly suggest.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Richard Burts Tue, 01/27/2009 - 04:31

Navinder

Perhaps it would help us figure out the problem if you would tell the exact command you try to use and the exact response that you receive. It might also be helpful if you would post the output of show diag from the router.

HTH

Rick

navinder.singh Tue, 01/27/2009 - 04:57

We are trying to give the card type on our NM module. Logs are attached.

As per Cisco Card type command is supported in 12.4 T Image.

Attachment: 
Paolo Bevilacqua Tue, 01/27/2009 - 09:44

Hi,

you need to contact the TAC on this issue, as it is not normal that the module is not recognized. In the manwhile you can try another image.

Hope this helps, please rate post if it does!

Actions

This Discussion