Load Balance with ASA using RIP

Unanswered Question
Jan 27th, 2009

Hi Guys,

a company asked me to do the following scenario,

2 routers connected to 2 different ISPs connected to layer 2 switch & they are using RIP, the switch should be connected to the ASA, and i suppose to configure the ASA using RIP dynamic routing instead of default route... (for outside)

any limitation or problems in this scenario?, i heard that using RIP on the ASA may make issues...

please advice..


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ramikamel911 Tue, 01/27/2009 - 19:25

Hi solpandor,

on PIX version 8 you can run RIP, so, by default ASA will be supporting RIP


This Discussion