Wireless controller: can it use Dynamic Interface to discover APs?

Answered Question
Jan 29th, 2009

Does the controller only use the management interface to discover and control APs?

In my case I created a dynamic Interface on the controller and it's in a different network than the management interface. The AP (which gets IP from a DHCP server) is in the same network with the dynamic interface. However the AP can't find the controller...

Is there anyway to make the AP be able to find the controller through the dynamic interface or it's totally impossible?

Thanks a lot!

Difan

I have this problem too.
0 votes
Correct Answer by sschmidt about 7 years 10 months ago

The dynamic interfaces are tied to the wlans for client access and the APs associate through the ap manager interfaces.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
sschmidt Thu, 01/29/2009 - 13:18

The dynamic interfaces are tied to the wlans for client access and the APs associate through the ap manager interfaces.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode