Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
375
Views
0
Helpful
2
Replies

Wireless controller: can it use Dynamic Interface to discover APs?

Go to solution
Difan Zhao
Level 5
Level 5

‎01-29-2009 12:13 PM - edited ‎07-03-2021 05:04 PM

Does the controller only use the management interface to discover and control APs?

In my case I created a dynamic Interface on the controller and it's in a different network than the management interface. The AP (which gets IP from a DHCP server) is in the same network with the dynamic interface. However the AP can't find the controller...

Is there anyway to make the AP be able to find the controller through the dynamic interface or it's totally impossible?

Thanks a lot!

Difan

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
sschmidt
Cisco Employee
Cisco Employee

‎01-29-2009 01:18 PM

The dynamic interfaces are tied to the wlans for client access and the APs associate through the ap manager interfaces.

View solution in original post

0 Helpful
2 Replies 2

Go to solution
sschmidt
Cisco Employee
Cisco Employee

‎01-29-2009 01:18 PM

The dynamic interfaces are tied to the wlans for client access and the APs associate through the ap manager interfaces.

0 Helpful

Go to solution
Difan Zhao
Level 5
Level 5
In response to sschmidt

‎01-29-2009 01:49 PM

Thanks a lot!

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card