Problems with L2tp/IPSEC Remote access VPN Gateway

Unanswered Question
Jan 30th, 2009

Hie guys!!! Please can you help me i am having problem connecting to my private lan using a windows client. I am simulating a vpn connection from inside my private lan.PPTP is working okay L2tp comes up with error 'remote machine did not respond' I have attached my router configuration and the debug output. My client config should be fine..What is wrong with my router config?????

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
celiocarreto Wed, 02/04/2009 - 08:40

Hi,

take a look here:

http://www.cisco.com/en/US/tech/tk827/tk369/technologies_configuration_example09186a00801e51e2.shtml

vpdn enable

vpdn-group 1

accept-dialin

protocol pptp

virtual-template 1

ip local pool test 192.168.1.1 192.168.1.250

interface virtual-template 1

encapsulation ppp

peer default ip address pool test

ip unnumbered FastEthernet0/0

no keepalive

ppp encrypt mppe auto

ppp authentication pap chap ms-chap

That's all.

Regards, Celio

doctorvelia Wed, 02/04/2009 - 22:32

Thanks Celiocarreto,,, I wanted to connect using l2tp/ipsec. With pptp my config work fine but then i just discovered that its NAT which is causing problems (the addresses being changed when i try to go out and then back inside) since i am emualting this inside my private lan.. I tested it from ouside and works fine....Topic Closed,,, Many thanks

Actions

This Discussion