LWAPP: QOS

Unanswered Question
Jan 30th, 2009
User Badges:

What is cisco best practice for a LWAPP port on an edge switch. WLAN is using 7921 handsets.


Should I use STP portfast ?

What QOS marking on the access port.




### current ####


int fa0/1

switchport

switchport mode access

switchport access vlan 10

mls qos trust dspc

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Stephen Rodriguez Fri, 01/30/2009 - 10:43
User Badges:
  • Purple, 4500 points or more

current setup is fine, recommended is to trust DSCP. As for spanning-tree configs, that's up to you. Spanning-tree portfast should be fine, could possibly use bpduguard enable if it's part of your normal edge security policy.


HTH,

Steve

Stephen Rodriguez Fri, 01/30/2009 - 10:44
User Badges:
  • Purple, 4500 points or more

current setup is fine, recommended is to trust DSCP. As for spanning-tree configs, that's up to you. Spanning-tree portfast should be fine, could possibly use bpduguard enable if it's part of your normal edge security policy.


HTH,

Steve

ericgarnel Fri, 01/30/2009 - 12:10
User Badges:
  • Gold, 750 points or more

Here is a helpful guide:

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a0080810880.shtml


Yes, use portfast on ap switchports, they are considered hosts.

You could also use the built in macro "switch host" (sw ho) which puts the port in access mode & porfast - a great combination with the interface range command.


I believe the dscp is correct (instead of cos)



Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode