Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
221
Views
0
Helpful
2
Replies

Tracking?

anowell
Level 1
Level 1

‎01-31-2009 12:05 PM - edited ‎03-04-2019 01:03 AM

<p>I have an 1841 with two internet circuits and I'm wanting to configure the circuits for failover.  Is there a way to have the router ping ISP1s default-gateway and if it fails use ISP2s gateway?  Please note that it is imperative I track an IP address rather then the state of the WAN interfaces.</p>

<p>Thanks in advance!</p>

Labels:
0 Helpful
2 Replies 2

Gregory Camp
Cisco Employee
Cisco Employee

‎01-31-2009 12:11 PM

Check out this link.  You can use IP SLA and link a track object to it.

http://www.cisco.com/en/US/docs/ios/12_3/12_3x/12_3xe/feature/guide/dbackupx.html

0 Helpful

Richard Burts
Hall of Fame
Hall of Fame
In response to Gregory Camp

‎02-01-2009 02:28 PM

Anthony

The link provided by Greg is pretty good and should show you what you need to do. I set up something pretty similar to what you describe. I did it on 2800 rather than 1800 but it should work well for you on your 1841.

HTH

Rick

HTH

Rick
0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card