PIX 501 Startup.html

Unanswered Question
Feb 2nd, 2009

Our PIX 501 has not been used in about a year. I want to configure it. I can get a login box when I go to I leave the user name and password blank and then I get the "Wait while startup Wizard loads" But nothing happens. That is as far as I can get. I've tried using a Vista machine with IE 7, and an XP machine with IE 6. Both give the same result. Any suggestions?? Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
eddie.mitchell@... Fri, 02/06/2009 - 07:19

Do you have the light blue Cisco console cable and a laptop with a serial port? Connect it to the console port on the PIX, launch Hyperterminal (9600-8-N-1) and you're good to go. Default login should be pix/, then enable and for the password.

Hope this helps.


This Discussion