I have tried setting the time and date in the CUE GUI and using the CCA. The time and date shows correct in both applications. When I go to the CLI and do a shiw clock I get the following
sh clock cme 18:51:52.199 EST Mon Feb 2 2009
sh clock cue 20:22:44.987 EST Sat Jan 31 2009
I can set the time zone in the cue but can not set the date and time, does anyone know how to set the time and date in the cue using the cli?
The "trick" here is that CUE must use NTP
Have you tried these commands?
Problem: CUE Clock Not Synchronizing with CME Router Configured as a NTP Server
NTP on the CUE is unable to synchronize with the CallManager Express. The CallManager Express router is configured as a NTP server. The CUE clock is not displaying accurate time. However, CallManager Express displays the correct time.
Issue these commands in order to overcome this problem:
On the CallManager Express router:
On the CUE:
ntp server x.x.x.x
!--- Where x.x.x.x is the ip address of the CME router which is configured as a NTP server.
Once the mentioned configuration changes are made on the CUE and CallManager Express, issue the show ntp status command on the CallManager Express router. You should see that the clock is synchronized.
Hope this helps!