×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Incoming CALL

Unanswered Question
Feb 3rd, 2009
User Badges:

hi,

i have configured a H323 getaway with a Cisco unified 7.0.

for the all incoming call i configured that to be destined to the extension number 1000 .

but if i change the partition + CSS form NONE , no incoming call is ringing.

also want to enable the caller id for the incoming call??


the IOS version is (C2800NM-IPVOICEK9-M), Version 12.4(22)YB.


Many thanks in advance



Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jaime Valencia Tue, 02/03/2009 - 07:30
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

dial-peer voice 1001 voip

destination-pattern 1000

progress_ind setup enable 3

session target ipv4:192.168.31.2

dtmf-relay h245-alphanumeric

codec g711ulaw


that's the dial-peer you're using, that simply tells which CUCM to send the H225 signaling. in CUCM you still need to have a valid incoming CSS configured under the H323 GW to reach DN 1000 on whatever partition it is


HTH


java


if this helps, please rate

Actions

This Discussion