cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
528
Views
0
Helpful
1
Replies

LMS Authentication Failure

bgl-group
Level 1
Level 1

This was working up until last week but now when I try to log into LMS I just get an authentication failure message.

LMS is configured to use ACS for access but ACS is not writing any information in the log files for the LMS server. So I can only assume that there is a problem with the link to ACS

How can I gain access to LMS and allow me to switch the system to a non-acs mode so I can access the server without first having logged in?

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

From the CLI, run the command:

NMSROOT/bin/perl NMSROOT/bin/ResetLoginModule.pl

You will then be able to login using local authentication and authorization.

View solution in original post

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

From the CLI, run the command:

NMSROOT/bin/perl NMSROOT/bin/ResetLoginModule.pl

You will then be able to login using local authentication and authorization.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: