Fram relay Issue

Unanswered Question
Feb 4th, 2009
User Badges:

Hi,

pvc Active but unable to ping POINT TO POINT network .The following configuration is as follows.please help


R1


interface Serial0/0/1

ip address 20.20.20.1 255.255.255.0

encapsulation frame-relay

clock rate 2000000

frame-relay lmi-type ansi


R2

interface Serial0

ip address 20.20.20.2 255.255.255.0

encapsulation frame-relay

frame-relay lmi-type ansi

!

FR Switch


interface Serial0

no ip address

encapsulation frame-relay

no fair-queue

frame-relay lmi-type ansi

frame-relay intf-type dce

frame-relay route 100 interface Serial1 101

!

interface Serial1

no ip address

encapsulation frame-relay

clockrate 64000

frame-relay lmi-type ansi

frame-relay intf-type dce

frame-relay route 101 interface Serial0 100


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Wed, 02/04/2009 - 04:38
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Manjunatha,

you are using the physical interfaces on R1 and R2.


add


R1

int ser0/0/1

frame-rel map ip 20.20.20.2 100 broadcast


R2


int ser0

frame-rel map ip 20.20.20.1 101 broadcast


or the opposite (the dlci parameter is the local one 100 or 101)


Hope to help

Giuseppe


Richard Burts Wed, 02/04/2009 - 04:40
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

It appears that your configuration is depending on Inverse ARP to map IP address to PVC. Could you post the output of show frame-relay map so that we can verify if the correct mapping has been established?


HTH


Rick

ntmanjunath Thu, 02/05/2009 - 21:28
User Badges:

Router#sh frame-relay map

Serial0 (up): ip 20.20.20.1 dlci 100(0x64,0x1840), static,

broadcast,

CISCO, status deleted

Richard Burts Fri, 02/06/2009 - 12:50
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

This additional information is helpful. I believe that this:"status deleted" is an indication that the PVC is no longer active. Find why it is deleted instead of active and you will find how to get it to work.


HTH


Rick

1lumkk Fri, 02/06/2009 - 18:15
User Badges:

Hi,


The status deleted indicates that the PVC has been erase from the service provider database. If the pvc is configure but not activated, it will appear as "Inactive". Hence, i would recommend to check with your provider for confirmation. Hope this give u a thinker. Rgds.

Edison Ortiz Fri, 02/06/2009 - 18:30
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

Let's identify what each router is learning from the frame-relay switch.


If you post the output from show frame pvc it will helps determine if you have the correct FR mappings.


It seems you are mapping 20.20.20.1 to an incorrect DLCI.


HTH,


__


Edison.

Actions

This Discussion