Hi,

<br />

<br />I just get a brand new cisco 2801 and a VIC2-2FXS that I install in the slot 0 (VIC only).

<br />

<br />I can see my card in the sh diag and sh ver but the voice ports never appear on the sh run. I can't type voice-port either...

<br />

<br />Router#sh ver

<br />Cisco IOS Software, 2801 Software (C2801-IPVOICE-M), Version 12.3(11)YZ2, RELEASE SOFTWARE (fc2)

<br />Technical Support: http://www.cisco.com/techsupport

<br />Copyright (c) 1986-2007 by Cisco Systems, Inc.

<br />Compiled Wed 08-Aug-07 23:47 by dchih

<br />

<br />ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)

<br />

<br />Router uptime is 21 minutes

<br />System returned to ROM by power-on

<br />System image file is "flash:c2801-ipvoice-mz.123-11.YZ2.bin"

<br />

<br />Cisco 2801 (revision 7.0) with 115712K/15360K bytes of memory.

<br />Processor board ID FCZ124611SS

<br />2 FastEthernet interfaces

<br />2 Voice FXS interfaces

<br />DRAM configuration is 64 bits wide with parity disabled.

<br />191K bytes of NVRAM.

<br />62720K bytes of ATA CompactFlash (Read/Write)

<br />

<br />Configuration register is 0x2102

<br />