02-04-2009 09:03 AM - edited 03-11-2019 07:45 AM
When I do a 'show run' command it scrolls all the way through the whole thing without page breaks. I have quite a long config so this is an issue because I can't see what is at the beginning of the config. It happens if I telnet or SSH and with different programs. Anyone know how to correct this?
*EDIT*
It's not just 'sh run'. It happens with anything I display with the show command.
Solved! Go to Solution.
02-04-2009 09:38 AM
Sorry I assumed you were using a switch/router firewall. Please try pager 30 from the config mode:
ASA5510-FW1(config)# pager 30
regards
02-04-2009 09:30 AM
you might have term length set to zero in your configuration. Try to set term length to a specific number such as
term len 30
regards,
02-04-2009 09:31 AM
I don't see a way to set term length, only term width.
02-04-2009 09:38 AM
Sorry I assumed you were using a switch/router firewall. Please try pager 30 from the config mode:
ASA5510-FW1(config)# pager 30
regards
02-04-2009 09:41 AM
Sorry, I probably should have clarified I was using an ASA 5510. Your solution worked, thank you.
02-04-2009 12:23 PM
I am glad I was able to help out and thanks much for rating the post. We all learn from this forum and it is great when folks rate helpful posting.
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide