DMVPN Behind NAT Device

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Ivan Martinon Wed, 02/04/2009 - 17:24
User Badges:
  • Cisco Employee,

When the spoke generates the registration request to the hub, this request will be NATed by the router/device infront of the spoke, so what comes to the hub is the NATed address of the spoke, I can't recall exactly but I believe you need to use Transport mode in order to nat the ip address within the IPSec header and to avoid issues.


This Discussion