Ericsson MD110 cisco 2811 and isdn BRI

Unanswered Question
Feb 5th, 2009
User Badges:

Hi to all,


i have an ERISCSSON MD110 PBX connecte via an isdn BRI interface to a cisco 2811.I can see the bri interface up,up ma i can't see q921 signaling passing through the interface and i can't place calls.

PBX has QSIG GFP(the PBX manager told me) signaling type and i configured basic-qsig under BRI.

any idea?


thx....

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
alessandro.dona Thu, 02/05/2009 - 08:44
User Badges:

No i'm using a crossover(3-->4,4-->3,5-->6,6-->5) i tried yestarday also with the combination shown in your link but it did not work.maybe some problem with qsig GFP


paolo bevilacqua Thu, 02/05/2009 - 08:47
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

No it must be done as per link, configure properly and it will work.

paolo bevilacqua Thu, 02/05/2009 - 08:54
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Alessandro, what should I explain, it's all in the document. Currently you have the wrong cable and not posted your config.

alessandro.dona Thu, 02/05/2009 - 09:11
User Badges:

interface BRI0/3/1

no ip address

isdn switch-type basic-qsig

isdn overlap-receiving T302 3000

isdn protocol-emulate network

isdn layer1-emulate network

isdn incoming-voice voice

isdn T310 120000

isdn static-tei 0

isdn skipsend-idverify

isdn layer1-emulate network


and also i find this combination(see attached.




paolo bevilacqua Thu, 02/05/2009 - 09:41
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Seems fine, you don't need

isdn T310 120000


The diagram you posted is pin numbers and functions, not the cross-over cable wiring.

Actions

This Discussion