upgrade ccm 3.3 to 6.1(2)

Unanswered Question
Feb 5th, 2009
User Badges:

What is the best process for upgrading 3.3 to 6.1?

We have new servers for 6.1 and they have been licensed by Cisco.

I am not sure how to move the config, phones, jtapi, etc...all the stuff over to 6.1? I also do not know Linux system?


Thanks.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jaime Valencia Thu, 02/05/2009 - 08:42
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

there is no direct upgrade to 6.1(2) from your version, 4.1(3) is the minimum to use DMA and get the info automatically


if you need to do it directly you'll have to export all the info with BAT and then reformat and reinsert into 6.1(2) with BAT as well


HTH


java


if this helps, please rate

dakshash_shah Thu, 02/05/2009 - 08:45
User Badges:

Hello Java,


Thank you for your reply.


I knew there was not direct upgrade, that is why we got new servers.

Where can I find info on how to use BAT and what info to collect to export into 6.1(2)?

How do I access the GUI once the MCS server is up on the 6.1(2)?

what do you mean by reformat?


Thank you.


Doc

Jaime Valencia Thu, 02/05/2009 - 08:51
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

BAT info is available on CCO, you'll have to export all details

simply http://server_IP from another PC, NOT FROM THE SERVER

BAT formats are not the same between versions, it's not as simple as taking a file and using it in another version. you'll have to adjust the info to the format needed for the new version


even if your servers supported the version still there's not upgrade. read the upgrade instructions to understand how this goes because fresh or upgrade you need to blow out all the previous info independently it's a new/old server. it's not as running a .exe and got the new version just like that


HTH


java


if this helps, please rate

Actions

This Discussion