cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
544
Views
0
Helpful
2
Replies

MTU on PIX for DSL

rstevek
Level 1
Level 1

Hi all,

I have a PIX where the outside interface is connected to a DSL modem. The PIX is configured for PPPoE on the outside interface. I know that the typical MTU size is 1500 for Ethernet and 1492 for PPPoE.

Should I set the MTU to 1492 on the outside interface of the PIX, or does the MTU only need to be set properly on the DSL modem?

Any help is very much appreciated.

Thanks,

- Steve

1 Accepted Solution

Accepted Solutions

celiocarreto
Level 1
Level 1

Hi,

I implemented a lot of ASA with DSL and never changed the MTU size on ASA. Only on routers (1492).

Currently no complains received.

Regards, Celio

View solution in original post

2 Replies 2

celiocarreto
Level 1
Level 1

Hi,

I implemented a lot of ASA with DSL and never changed the MTU size on ASA. Only on routers (1492).

Currently no complains received.

Regards, Celio

Hi Celio,

Thanks for the reply. I found out that, when you use the ip pppoe setroute command, the MTU for that route is automatically set to 1492.

Thanks,

- Steve

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: