clns routing

Unanswered Question
Feb 5th, 2009
User Badges:

could someone explain the below command to me... thanks:

<br />

<br />mpls ldp neighbor 192.x.x.1 password 7

<br />mpls label protocol ldp

<br />no issu config-sync policy xxx xxx

<br />issu config-sync policy xxx xex

<br />

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
royalblues Thu, 02/05/2009 - 14:00
User Badges:
  • Green, 3000 points or more

mpls ldp neighbor 192.x.x.1 password 7

This command configures a passowrd with the LDP neighbor. The number 7 indicates that the passord that will follow will be encrypted with type 7.

mpls label protocol ldp

The global mpls label protocol ldp command sets the default label distribution protocol for all interfaces to be LDP.

issu config-sync policy

When two different versions of Cisco IOS images are involved, there is a possibility that the command sets supported by two images might differ. If any of those mismatched commands are executed on the active supervisor engine, the standby supervisor engine might not recognize those commands. This causes a Config Mismatch Condition

The no form of the command removes the defined policy




This Discussion