02-05-2009 08:27 PM - edited 03-04-2019 01:08 AM
I have one problem about QoS with router which configured as Service Provider recommended(int BVI).
After I made QoS configuration and I applied it to s0/0/0 interface.
Then I confirmed it's working or not by using command
"show policy-map int s0/0/0"
But result show that no packet goes to each classes.
Then I tried to research to create new policy to apply on sub-interface.
After that still same result(no packet goes to each classes).
So I made one access-list permit ip any any to check matched packets on s0/0/0
and s0/0/0.1, result is no matched packet though these 2 interfaces.
And if I put same access-list on BVI interface, they could show many matched packets.
But big problem is I could not apply CBWFQ or GTS (Shaping) to BVI interface for making QoS.
I already tried hard to research but still not get some answer.
So I decided to ask for help from expert here, could you please help me.
:)
Note: Another sites, without BVI interface but same configuration
are working fine until now.
02-11-2009 12:33 PM
Understanding Packet Counters in show policy-map interface Output.
http://www.cisco.com/en/US/tech/tk543/tk760/technologies_tech_note09186a0080108e2d.shtml#confirmpol
09-09-2010 07:48 AM
I've got the same issue here - does anyone have any ideas?
Thanks guys!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: