02-06-2009 08:52 AM - edited 03-15-2019 04:02 PM
I have a cisco GW connected to PBX Nortel, whe I make a phone call from the ip phone it travel to the ccm-GW-PBX-ISP.
It always take the channel 31, and then I tray to make a second call and send a busy tone.
Then if in the timeslot I change the 1-31 to 1-30, and i try to make a call it says "the call cannot be possible as you dialed".
Then if in the serial :15 interface i configure de ascendng or descending command, and I try to make a phone call it send me a busy tone.
Any Idea?
02-06-2009 09:58 AM
It sounds like you need to sync your configuration with the Nortel. They may not be configured with the same channel group you are.
This doesn't sound like an issue that we would be able to change on our gateway, after your troubleshooting.
hth,
nick
02-07-2009 09:55 PM
Yor were rigth, there was a privileges issue in the nortel PBX, thnks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide