02-06-2009 12:02 PM
I am trying to set up some pulling of CPU, memory utilization and environmental polling. I have the pollers set up and used the appropriate instances, but my portlet says that there is no data to display. Trying to figure out why.
02-06-2009 01:18 PM
What version of HUM? What are the statuses of your pollers?
02-06-2009 01:22 PM
version is 1.0 and my pollers are active. I have one poller polling several differnet templates and instances. Some of them, seem to be getting info just fine, others do not.
02-06-2009 01:28 PM
Did the portlets ever show data available? Or have they always reported no data since defining the pollers?
02-06-2009 01:49 PM
always reported no data since defining the pollers, for a few templates I am using, not all of them.
02-06-2009 01:58 PM
How are your problem pollers defined? What templates are you using?
02-06-2009 02:06 PM
I have one poller called core switch, I am using the cpu utilization, temp, interface utilization and memory utilization templates. I have all available instances checked.
I then have portlets set up to show top N cpu utilization, top n memory, top N interface utilization. My top n interface utilization is showing me the info, but the others say no data to display. This poller is the only one using the cpu memory & environmental temp templates so it has to be among the top N cpu because it is the only one.
02-06-2009 04:02 PM
ok, I just noticed that my memory utilization started showing data. Several hours after I configured the pollers. Does it just need to poll a certain amount of data before it shows results?
02-06-2009 07:18 PM
The HUM portlets should start showing data after two polling cycles.
02-06-2009 07:46 PM
that is not what is happening. Also, my memory stats disappeared and now says that there is no data to display.
02-06-2009 07:48 PM
Please post the HUMPortal.log.
02-09-2009 10:35 AM
The file is 7 meg in size. Each time I try to attach it, I get a time out and page cannot be displayed.
02-09-2009 10:44 AM
The file is pure text. Just compress it, and you should be able to post it.
02-09-2009 10:51 AM
02-09-2009 10:56 AM
The underlying queries are not finding any data. Go ahead, and delete your current poller, and recreate it. We've seen cases where this can get the real-time data to show up in the portlets.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: