L2 VPLS 7206VXR

mugahid-mustafa · ‎02-08-2009

I am configuring 7206VXR (IOS 12.4(11)T); as the following:

7206(config)#l2 vfi VPLS-Test ?

point-to-point Point-to-point configuration mode

for l2 vpls there is only one option p-to-p, i can't find manual option on this IOS!! do i need to change this ios or what?

The command should be like this #l2 vfi VPLS-Test manual. Becuase using p-to-p option i can configure only 2 peers.

Any work around?

Regards

shivlu jain · ‎02-08-2009

Mustafa

7206 doesnot support VPLS. For VPLS configuration minimum requirement is 7600 with sip/spa card. On 7206 you can configure only point to point l2 circuits.

If would be better to create a psudowire and bind it to some interface.

regards

shivlu jain