AIR-AP1252G-E-K9 access point and AIR-WLC4402-50-K9 controller

Unanswered Question
Feb 8th, 2009
User Badges:

I have configured AIR-AP1252G-E-K9 (lightweight)and AIR-WLC4402-50-K9 controller and connect within same LAN but AP is not showing in the controller, please help


controller configuration is attached


Regards,

Majid



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
krishanmistry Mon, 02/09/2009 - 03:37
User Badges:

Please provide more information e.g:


What software version is running on the WLC?


What is providing DHCP, and what is the scope?


Have you tried any debugs on the controller to see any LWAPP join requests, reaching the controller.


Regards

dennischolmes Mon, 02/09/2009 - 04:31
User Badges:
  • Gold, 750 points or more

You mention above the part number for a autonomous AP then state it is LWAPP. Was it converted? If it was, is it attaching to the same controller it was initially attached with in the conversion process? If not, the SSC is the issue. You must install the SSC hash on the controller. Next, look at the date and time on the controller to insure accuracy. Next is the AP getting an IP address on the same subnet as the controller management and AP manager interface? If not then insure you get an IP address and enable option 43 or DNS lookup of the controller.

captainmajid Mon, 02/09/2009 - 09:31
User Badges:

Hi, thanks for your response


A) Yes, I converted the following AP from autonomous to lightweight mode but with the help of (CiscoAironet-AP-to-LWAPP-Upgrade-Tool-v34), not through attaching the controller


B)Please tell me the steps of, how to install SSC hash on the controller and DNS related configs


Thnks & Best regards,

Majid


Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode