WS-SVC-CMM connectivity problem

Unanswered Question
Feb 9th, 2009

Hi to all,

I have a WS-SVC-CMM in a catalyst A and I have a connectivity problem, I have some Ip phones in catalyst C but if I ping from the WS-SVC-CMM there is no ping but from the catalyst Aºwhere the WS-SVC-CMM is installed I ping them and if ping from the card to this catalys is ok, I supposed I need some command to ping from WS-SVC-CMM.

Best regards,


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
jbayuka Sat, 02/14/2009 - 16:57

Configure the CMM in bus mode.

Issue the fabric switching-mode force bus-mode config command. This command forces the fabric connection of the service module to bus mode.


This Discussion