02-09-2009 05:28 AM
I have created a ravpn on tha ASA 8.0(4)(resently upgraded).
The clients can connect fine but they cannot ping the inside network of the asa.
I have included the the vpn pool on the no nat access-list.
What i observed was that when i ping from the asa the raclients, it is successful!!!!
After I do so then everything seems to work fine!! Isn't it strange?
Solved! Go to Solution.
02-09-2009 12:55 PM
Michalis, glad it worked, could you PLS rate post as resolved.
B.Regards
02-09-2009 08:31 AM
Michalis,
make sure you have in asa nat-t enable as this is one of the most common symptoms from what you are describing.
asa(config)#crypto isakmp nat-traversal 20
http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a00807e0aca.shtml#Solution1
if you do already have this statement PLS post sanitized ASA config .
Regards
PLS rate any helpful posts
02-09-2009 12:03 PM
Great it was that command!!!!!!
Thanks a lot man!!!
Problem solved!!!
02-09-2009 12:55 PM
Michalis, glad it worked, could you PLS rate post as resolved.
B.Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: