Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
411
Views
0
Helpful
1
Replies

Bandwidth command on Interface

ronald.ramzy
Level 1
Level 1

‎02-09-2009 11:34 AM - edited ‎03-06-2019 03:56 AM

Hi,

We have 2MB Link from Service-Provider terminated on a Router. The link is 2MB.

I configured the Interface with "Bandwidth" command so that MRTG gives me proper Utilization of incomming and outgoing traffic.

But it doesnt seems to give bandwidth.

Can someone help what could be wrong with it.

Interface fa 0/0

bandwidth 2048

Description connected to ISP

Labels:
0 Helpful
1 Reply 1

Yudong Wu
Level 7
Level 7

‎02-09-2009 12:34 PM

The bandwidth command sets an informational parameter to communicate only the current bandwidth to the higher-level protocols; you cannot adjust the actual bandwidth of an interface using this command.

Note This is a routing parameter only. It does not affect the physical interface.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card