02-09-2009 01:17 PM
Hi All,
I have 2ASAs in Active/standby with stateful failover mode. Planning to upgrade IOS. Wanted to disconnect Standby from network first and upgrade the IOS. Now, the inside interface config..
********************************
interface GigabitEthernet1/0
nameif inside
security-level 100
ip address 192.168.20.6 255.255.255.192 standby 192.168.20.7
**************************
When the standby unit is disconnected and connect the laptop directly with Xover cable, if I assign my laptop with any ip in the inside interface subnet range, will it work or due to standby ip config, any issue will be there..?
TIA
MS
02-09-2009 11:21 PM
Hi,
there shouldn't be any issue. I did the same.
Regards
AP
02-10-2009 08:14 AM
Thank you for the reply. It worked.
MS
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: