Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
251
Views
5
Helpful
1
Replies

Config serial int as well as serial controller?

bmckean
Level 1
Level 1

‎02-09-2009 02:06 PM - edited ‎03-04-2019 03:29 AM

I'm getting ready to start configuring on a new 3845 ISR with a NM-1T3/E3. After reviewing lots of documents as well as forum searches, I'm not sure if I have to configure the routers serial interface in addition to setting the NM-1T3/E3 card type, controller slot, framing…

Thanks

Labels:
0 Helpful
1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

‎02-09-2009 02:29 PM

You configure:

card-type (mandatory)

controller (optional, in most cases no changes to default)

interface (of course, mandatory)

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card