Analog port in SRST

Unanswered Question
Feb 9th, 2009

Hi All,

I am using MGCP with CUCM 7.0. Should I configure "connection plar" under voice port configuration for analog ports FXO in SRST mode?

thanks

Alex

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
andresfmg Sun, 11/01/2009 - 08:26

hi i have yhe same issue, i have a gateway srst and the ports are controled by the cucm with mgcp, every work just fine, but when then connection fails, and the router up the srst mode i can get anything , becouse the comandas connection plat under the ports, are not reconized becouse are in mgcp, ??there is any solution ???

Actions

This Discussion