Problem with FXO script CUE

Unanswered Question
Feb 10th, 2009

Hello, I have a problem when forming a port FXO that aims at script in the CUE. It leaves the menu correctly but when beating the wished option the CUE does not realize. I imagine that it is a problem with the signaling but not that changes I must realise.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Tue, 02/10/2009 - 04:34

Of what you wrote (or translated automatically), very little can be understood.

However, have you configured "dtmf-relay sip-notify" under the DP for CUE ?

sruizpla Tue, 02/10/2009 - 05:12

Hello, thanks to answer and sorry for my auto translate.

I have configured a port FXO that forwards the call to script of module CUE with menus (Press 1 for contact with Administration, press 2 for ....) The call enters correctly, but the system does not recognize the pulsations of my keyboard, I suppose that it is a problem with the signaling.

I have next configuration in my gateway of the dial peer and voice port :


dial-peer voice 2 voip

description Local AIM Auto Attendant

destination-pattern 1921

session protocol sipv2

session target ipv4:

dtmf-relay sip-notify

codec g711ulaw

no vad


voice-port 0/0/3

no echo-cancel enable

cptone ES

timing hookflash-out 500

connection plar opx 1921

impedance complex2


Also I have a line ISDN and it works fine, the problem this in port FXO.

Thank you.


This Discussion