02-10-2009 08:05 AM
Hi
I am trying to find out if there is a way to set a source interface for a VPN that is ran on the IOS. The router in question is a cisco 871
The config has Nat running with 5 IP's
Four of the are static entries ending in
.193 overload and assigned to the fast Ethernet port of the router
.194 assigned to a pc
.195 assigned to a pc
.196 assigned to a pc
.197 assigned to a pc
I am not sure as to what IP the router will listen for incoming VPN connections
02-10-2009 08:44 AM
All the interface address.
02-10-2009 08:51 AM
OK so if it is listening on all addresses with that have an effect on the client mapped to say .195?
02-10-2009 11:49 AM
No. Interface addresses are not static nat addresses.
02-11-2009 04:05 PM
If you are asking what IP address the router will accept incoming connections on it's the interface that has ISAKMP enabled on it typically the outside interface.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: