I'm a little confused with something. I've got one of these routers (Cisco 1760 onboard fa0/0 and 1 ea. FXO, FXS) on-site now (I've completed voip config - just need to set with static ips and then play with the VPN). I've got the other at the office obtaining a DHCP WAN IP, and the second is on-site behind a Centurytel westell wireless router/modem. The modem has had firewall off and the public LAN enabled, which allows multiple static WAN IPs to be addressed to equipment behind the westell modem/router.
The problem is, is that the Cisco is not getting out to the internet, nor can internet access the router. When I configure my laptop nic with the same settings, everything works fine. There is nothing in the westell that is blocking anything, so I don't understand this. 1st router with 1st IP, along with the computers on the 1st LAN are able to ping the Cisco with 2nd IP, and the Cisco is able to ping its default-gateway, which is the 1st router/1st IP address, but cannot get past the 1st router, and nothing from the internet trying to access the 2nd IP can get past the 1st router.
Here's the IP configs:
Cisco Interface Fa 0/0:
IP default-gateway 18.104.22.168 & IP route 0.0.0.0 0.0.0.0 Fa 0/0 Have both been tried.
I've got the 2nd Cisco router, back at the office, right now accessible from the internet and has internet access on the fa 0/0 int using DHCP.
I'm pretty sure this has to be some count of IP route problem. I saw in the IP route table of the 2nd router at the shop, that it added a static route to another network via fa 0/0, which I can only assume is the multicast network that our cable modem is connected to. I'm wondering if the same would have to be added for the 1st Cisco with the 2nd static IP from the DSL connection?
Here's the table from the first router:
Gateway of last resort is 22.214.171.124 to network 0.0.0.0
172.24.0.0/32 is subnetted, 1 subnets
S 172.24.120.69 [254/0] via 126.96.36.199, FastEthernet0/0
188.8.131.52/24 is subnetted, 1 subnets
C 184.108.40.206 is directly connected, FastEthernet0/0
C 192.168.1.0/24 is directly connected, Loopback1
S* 0.0.0.0/0 [1/0] via 220.127.116.11
AND HERE'S THE TABLE FROM THE 2ND ROUTER:
Gateway of last resort is 0.0.0.0 to network 0.0.0.0
C 192.168.10.0/24 is directly connected, Loopback1
18.104.22.168/30 is subnetted, 1 subnets
C 22.214.171.124 is directly connected, FastEthernet0/0
S* 0.0.0.0/0 is directly connected, FastEthernet0/0
I've also just tried to give the int fa 0/0 a private LAN address here, and assign default route to fa 0/0 and default-gateway to 192.168.1.1 (westell router) and still the same thing is happening. I don't understand this. It's not like the interface is bad or anything, and before I left the office with this, it was connected to that cable connection and obtaining a DHCP and everything works fine there. I know this has to be something really simple like a route or something. I thought it might have had something to do with the VPN config that I had started, and so I removed the crypto map from the fa 0/0 int, but still no go.
Anyway...I thought I'd include the config for this setup (being on the private LAN):