WLC - Domain name configuration....

Unanswered Question
Feb 12th, 2009

hi All,

I am trying to configure the domain name in wlc but i am not geeting the option.

If i checked the sh cdp nei on switch where my LWAPP connected....its showing...

puna-wpi-ap-1g.cisco.com....

where i think cisco.com is default domain.

So pls give me the appropriate solution to configure the domain in WLC.

Waiting for the reply ASAP.....

Thanks & Regards,

RAJU

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jeff.kish Thu, 02/12/2009 - 07:45

What version code are you running? I seem to recall that in early versions of code this cannot be changed.

jeff.kish Fri, 02/13/2009 - 07:16

I think you need to be on 5.0+ to modify the domain name.

Can anyone else confirm that?

Stephen Rodriguez Mon, 02/16/2009 - 14:46

4.2 shouldn't have had an issue with the domain name, I believe that started in 5.0, and was fixed in 5.2. If the AP is getting DHCP, then the domain name should be set from the DHCP option. If you are using static, you would need to use a command to gain access to the CLI of the AP to set it, but it will not persist through a rebot as you cannot write to the memory of an LWAPP AP.

HTH,

Steve

Actions

This Discussion