cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
973
Views
9
Helpful
6
Replies

Reload manual or power off on router

yavuz.ozdemir
Level 1
Level 1

Dear,

We have router which is up since 2 days and I would like to know if the router has reloaded by CLI (Reload) or by power off(Electrical problem)

ROM: System Bootstrap, Version 12.4(12.2r)T, RELEASE SOFTWARE (fc1)

BOOTLDR: Cisco IOS Software, 7200 Software (C7200P-KBOOT-M), Version 12.4(4)XD9, RELEASE SOFTWARE (fc1)

Router-Test-01 uptime is 2 days, 21 hours, 0 minutes

System returned to ROM by reload at 16:54:56 UTC Mon Feb 9 2009

System restarted at 16:56:23 UTC Mon Feb 9 2009

Last reload reason: Reload Command

Last reset from power-on

1 FastEthernet interface

4 Gigabit Ethernet interfaces

2045K bytes of NVRAM.

6 Replies 6

andrew.prince
Level 10
Level 10

it was manuall reloaded from the cli.

How you can say it?

This statement indicates it...

Last reload reason: Reload Command.

If it helps, please rate post..

Thanks, I rate it

Hello,

Because the output says

"System returned to ROM by reload at 16:54:56 UTC Mon Feb 9 2009"

If it was a power problem it would have said something like

"System returned to ROM by unknown reload cause"

Thanks

Leo Laohoo
Hall of Fame
Hall of Fame

They're all right. The second and the last line always gives you a clue.

If it's a power outage, the line would go something like "System returned to ROM by power-on".

If there was something wrong, in this case a system crash, you'd get an alarm like this:

System returned to ROM by error - Software Forced Crash Exception (0x0700)!, PC 0x3ED134

System restarted at 05:10:29 AEDST Tue Nov 18 2008

If it was reloaded, you still get this

System returned to ROM by reload at 15:55:01 AEDST Fri Feb 6 2009

Does this help?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: