Time-based access controls

Unanswered Question

Hello all,

Is there a time-based access control that can be configured for a 4.2 WCS+WiSM setup either in the WCS or controller? Or am I limited to the ACLs for my Wireless VLAN on the switch. Ultimately, I would like to be able to configure certain APs to accept/deny connections at specific times of the day. Any suggestions would be appreciated. Thank you in advance for your time and help.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
amritpatek Thu, 02/19/2009 - 19:26

Currently, IP and IPX extended access lists are the only functions that can use time ranges. The time range allows the network administrator to define when the permit or deny statements in the access list are in effect. Prior to this feature, access list statements were always in effect once they were applied. Both named or numbered access lists can reference a time range.

For the further description following URL for the Time-Based Access Lists will help you.


I hope it may help you.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode