02-12-2009 08:44 PM - edited 07-03-2021 05:09 PM
HI...I got 4 aironet 1310ï¼but i don't have password into Eanble mode!!
I follow this document "Password Recovery Procedure for the Cisco Aironet Equipment.pdf" to recovery password.
It succeed reset password to defaultï¼but it also reset Previous setting to defalut.
Can I reset aironet 1310 password and keep Previous setting? Plz!!
I really need help for this,thanks.
p.s My english not good
02-12-2009 08:53 PM
Username: Cisco
Password: Cisco
Enable Password: Cisco
Try this and I hope it works.
02-12-2009 11:51 PM
Thank you for reply
but can't help to me.
I seeking a way that can reset password to default and can keep Previous setting
thank you
08-30-2012 07:36 AM
years too late, but this might be helpful for someone else:
- Reboot the aironet
- As soon as you see the following, hit the ESC key twice to interrupt the booting process
flashfs[0]: 147 files, 7 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 7741440
flashfs[0]: Bytes used: 5544960
flashfs[0]: Bytes available: 2196480
flashfs[0]: flashfs fsck took 32 seconds.
Base ethernet MAC Address: 70:81:05:3a:75:0a
Initializing ethernet port 0...
Reset ethernet port 0...
Reset done!
ethernet link up, 100 mbps, full-duplex
Ethernet port 0 initialized: link is up
Loading "flash:/c1310-k9w7-mx.124-25d.JA/c1310-k9w7-mx.124-25d.JA"...############
- If you would like to view the old config, type the following command from the bridge: prompt
more flash:config.txt
- for password recovery, delete or rename the env_vars and config.txt files in flash:
bridge: dir flash:
Directory of flash:/
2 -rwx 5
3 -rwx 277
5 drwx 256
4 -rwx 1048
155 -rwx 1487
- when you are finished, boot the AP by typing in boot and hitting enter
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: