I have following topology,
I want to monitor 2 ports on SW1 and traffic analyzer is connected with SW3. I have configured RSPAN VLAN and defined source ports for monitor session on SW1, destination would be RSPAN VLAN. I am having confusion in configuring RSPAN parameters on SW2. On Sw2 I will have to configure 'monitor session 1 source vlan 500(RSPAN VLAN )' but what about destination ?
Can I configure RSPAN vlan both as source and destination ? or I need to configure trunk port b/w SW2 & SW3 as destination on SW2 ?
the vlan has to be defined as remote span vlan this is needed also on SW2.
Besides this SW2 needs only two trunk links where the remote span vlan is permitted
no monitor commands are needed on SW2
Hope to help