Unanswered Question
Feb 16th, 2009

Wer can I found information about how to configurin DID on the following scenary

Callmanager ver

H232 voice Gateway - E1 PRI

PTSN num - 2602300

Phone ext num 3xx

I want that when peopel call 2603301 it go to ext 301 and so

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jaime Valencia Mon, 02/16/2009 - 11:05

configure the GW as usual

on CCM significant digits set to 3

DNs using 3 digits



if this helps, please rate

Afragoso2009 Mon, 02/16/2009 - 12:33

Its already done .But in wath concerning the VOice Gateway?

Before , I have a plar connection , but all the call came just to one Phone

Jaime Valencia Mon, 02/16/2009 - 13:45

voip dial peer using the digits you expect to receive and send it to CUCM with session-target command



if this helps, please rate

Afragoso2009 Thu, 04/02/2009 - 02:18

Hi Adrian

I am using the foolowing dial-peer

dial-peer voice 300 voip

preference 4

destination-pattern .

session target ipv4:

dtmf-relay h245-alphanumeric

codec transparent

But any all the ext ( from 301 to 399 ) are receiving the call direct fom outside.How can I block some ext to not receive a call ?


This Discussion