DDI

Afragoso2009 · ‎02-16-2009

Wer can I found information about how to configurin DID on the following scenary

Callmanager ver

H232 voice Gateway - E1 PRI

PTSN num - 2602300

Phone ext num 3xx

I want that when peopel call 2603301 it go to ext 301 and so

Jaime Valencia · ‎02-16-2009

configure the GW as usual

on CCM significant digits set to 3

DNs using 3 digits

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

Afragoso2009 · ‎02-16-2009

Its already done .But in wath concerning the VOice Gateway?

Before , I have a plar connection , but all the call came just to one Phone

Jaime Valencia · ‎02-16-2009

voip dial peer using the digits you expect to receive and send it to CUCM with session-target command

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

Adrian Saavedra · ‎02-16-2009

Hi friend,

This is a good document for Understanding Direct-Inward-Dial (DID) on IOS Voice Digital (T1/E1) Interfaces:

Hope this info helps you!

Please rate useful posts.

Best regards,

- AdriÃ¡n.

Afragoso2009 · ‎04-02-2009

Hi Adrian

I am using the foolowing dial-peer

dial-peer voice 300 voip

preference 4

destination-pattern .

session target ipv4:172.19.0.253

dtmf-relay h245-alphanumeric

codec transparent

But any all the ext ( from 301 to 399 ) are receiving the call direct fom outside.How can I block some ext to not receive a call ?