02-16-2009 12:42 PM - edited 03-04-2019 03:35 AM
I have a 6500 L3 supevisor module and I am trying to access the NAM module in one of the slots. The session command does not work. Does anyone know the service command that allows access to the NAM module so I can configure it. This is rather urgent...need before 12:00 midnight if possible. Thanks
02-16-2009 02:58 PM
You can session into the NAM by isuing the following command "session X processor 1" command. Just replace X with the slot number the NAM is installed.
HTH,
Mark
07-15-2010 03:32 AM
i have two 6513 chasis configured in VSS Mode.I have two NAM modules in both the switches.I want to know what will be the status of NAM module in standby switch.
Regds
Nehal Modi
07-16-2010 12:04 AM
I have a 6500 L3 supevisor module and I am trying to access the NAM module in one of the slots. The session command does not work. Does anyone know the service command that allows access to the NAM module so I can configure it. This is rather urgent...need before 12:00 midnight if possible. Thanks
Hi,
Check out the below link for establish session with NAM
Hope to Help !!
Ganesh.H
Remember to rate the helpful post
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide