CUCM 6.1.1 phone firmware upgrade

Unanswered Question
Feb 17th, 2009
User Badges:


We are going to be upgrading our CUCM to version 7.x at some point in the very near future. I read that we have to be running 8.4.x firmware on the phones. I have downloaded 8.4.3 and I want to test it on a couple of phones before pushing it out to all of them. Can this be done?

Thanks, Troy

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Chris Deren Tue, 02/17/2009 - 13:45
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

Sure it can, download the service pack containing firmware file you are planning on using after the upgrade, install the service pack and it will change the device defaults to the firmware file included in it, then restart tftp server and all phones should download and install the firmware.



Jaime Valencia Tue, 02/17/2009 - 14:17
User Badges:
  • Cisco Employee,
  • Hall of Fame,


if the load has already been uploaded change the load info on the device config page of the phones you want yo try



if this helps, please rate


This Discussion