02-17-2009 09:10 PM - edited 03-04-2019 03:37 AM
Hi ,
There is a Channelised E1 output which is from mux . as my controller port is faulty can i connect this outout of e1 ( RJ45) to 2mb modem ( RAD ASM)(using WIC in router) and get the link through ?
Actually i tried it and failed .. is there any suggestions ?
02-17-2009 11:55 PM
Can you describe again what is that you want to connect and where ?
02-18-2009 01:43 AM
kindly check the switch setting at modem end.
regards
shivlu jain
02-18-2009 03:53 AM
If I understand the setup correctly, you will require a RAD convertor modem as the output that you are getting is G.703 which needs to be converted to V.35
02-18-2009 03:56 AM
The problem is that is not really clear what the OP wants to do.
Cisco routers have G.704/G.704 natively with the right cards and need no converters.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: